Gas Hot Water Repairs & Replacement in Leonay NSW

A renovation client wanted their old flued storage unit moved outside, so we ran a new gas line, installed a continuous flow unit and removed the redundant flue. Projects like that sit alongside day to day emergency hot water repairs, pilot and ignition faults, thermocouples and gas valves, leaking cylinders and TPR or tempering valve replacement. Routine servicing with anode, burner and TPR checks is part of the package too, on natural gas and LPG.

A pilot light that has simply blown out can sometimes be relit by following the instructions printed on the unit, and that is the one thing worth trying before you call. If it will not stay lit or you are unsure, stop there and ring us, because a repeatedly failing pilot usually points to a thermocouple or gas valve fault.

Coverage runs from the local area out through the neighbouring suburbs and into the nearby towns and rural districts. Repairs and servicing are concentrated nearer to home, while installations and bigger jobs justify a longer drive. Phone through with your location and we confirm it on the spot.

The price of a hot water replacement depends on what you are replacing and what you are moving to. A like-for-like storage cylinder swap sits at the simpler end, while changing to a continuous flow unit or increasing capacity involves more parts and labour. We look at the existing setup and provide a free written quote before any work starts.

The pilot jet is a tiny orifice, and its job is to shape a steady flame that sits squarely on the thermocouple tip. Dust, spider webs or corrosion narrow that opening, so the flame turns weak and yellow and drifts off the probe. Once the probe cools the safety shuts the gas, which is why a dirty jet is a leading cause of a pilot that keeps dropping out.

Australian law reserves gas appliance installation and repair for licensed gasfitters. Our team meets that requirement with current gasfitting licences held by every tradesperson, and the business carries public liability insurance. A compliance certificate is issued at the end of each job.

Our rule of thumb is that a straightforward part failure on a younger unit calls for a repair, while a worn-out cylinder calls for a new system. Thermocouples, pilot jets, TPR valves and igniters are routine replacements that give a sound unit many more years of service. A tank that has started to corrode cannot be patched, and a unit that needs attention every few months is quietly costing you more than it should. The quote we give you spells out both options so the decision is yours.

There is no need to take several days off work. A straightforward replacement is a few hours start to finish, and a change of system type or position is normally done within most of a day. One visit, one compliance certificate, hot water that night.

Every service follows the same core checklist no matter the age of the unit. Burner clean and flame check, gas pressure test at the regulator, thermocouple or ignition test, flue and draught check, TPR valve test, and tempering valve check with the outlet set to 50 degrees Celsius. Storage cylinders also get the sacrificial anode checked and a sediment flush where needed, continuous flow units get a descale or filter clean, and everything is rounded off with a leak and carbon monoxide test and a written report.

Book a periodic hot water service, as most manufacturers make regular servicing by a licensed tradesperson a condition of their cover. A service also catches small issues such as a tired anode or a weeping TPR valve before they damage the cylinder. The unit remains under the manufacturer’s warranty and our work under our guarantee the whole time.

You might notice water pooling near the base of the cylinder at the same time the hot water goes off. A TPR valve stuck open or a split tank will both leak, and a split tank usually means the system is at the end of its life. That is one for a licensed gasfitter rather than a patch, and the sooner it is looked at the less water damage you risk.

Choosing between them starts with your peak demand rather than your average use. A storage cylinder is sized by the volume it holds, so a large tank shrugs off a busy morning. A continuous flow unit is sized by flow rate in litres per minute, so the unit must be rated for every outlet you expect to run together. We size either option properly so you are not left short at the worst moment.